Accessories
Hydrofoil Spares
Slide Nuts
M8 Brass Sliding T Nuts
Used with most slide rails which are inserted within, or stuck onto the board surface.
Footstrap Inserts
M6 Stainless steel
Protected thread
T Nuts
M8 Stainless Steel
Barrel Sleeve Nuts
M8 Stainless Steel
Tail Fin
5cm Fibreglass
M6 Hole Pitch 38mm
Also suitable for kiteboards
Footstraps
Soft and Flexible
Narrow and Well Padded
Suitable for Gybing on Directional Boards
Board-Pedestal Coupling Plate
4mm Thick , 9mm holes
Hard Plastic
140 x 90 Hole Pitch
100 x 90 Hole Pitch
Shimming Coupling Plate
Used to shim away the tail rocker found when adapting normal surfboards.
Polyurethane
Can be angle sanded on lower surface and drilled to suit your particular board installation.
Imprinted bolt hole positions at 140mm x 90mm.
Height difference between rear and forward bolt positions is 10mm or 4 degrees which works well.
Accessories
Hydrobat
Riding On Rails !!
- Marked stability increase
- Far greater pitch control
- Increased lift and maneuvering time whilst remaining on foil
- Enhanced ability to remove and control foil speed when riding a wave
- Enhanced control relationship between the kite and the foil
- Faster, more controlled turning with a smaller turn radius
- Far greater control through wind gusts
- Better high and low end wind handling ability
Polyurethane Canalising Wing
Simple attachment to all wing sizes
M8 X 35 Stainless Steel Cap Screws